Kidde smoke alarm manual i12060

• Smoke alarms must be tested regularly to make sure the battery and the alarm circuits are in good operating condition. • Smoke alarms cannot provide an alarm if smoke does not reach the alarm. Therefore, smoke alarms may not sense fires starting in chimneys, walls, on roofs, on the other side of a closed door or on a different floor. Kidde alarms and accessories CAN ONLY BE interconnected with other Kidde alarms CONTENTS OF THIS MANUAL 1 -- RECOMMENDED LOCATIONS FOR SMOKE ALARMS 2 --LOCATIONS TO AVOID 3 -- INSTALLATION INSTRUCTIONS 4 -- OPERATION AND TESTING (i, i, i, , , , , PE, PI, KN-COSM-IB, RF-SM-ACDC. The smoke alarm shall be Kidde Model i or approved equal. alarms are wired to a single, continuous (non-switched) power line, which is not pro It shall be powered by a VAC, 60Hz source along with a 9V battery backup. The unit shall incorporate an ionization sensor with .

The Kidde iA is an AC/DC powered, ionization smoke alarm that operates on a V power source with 9V battery backup. This alarm uses ionization sensing technology. Ionization sensing alarms may detect invisible fire particles (associated with flaming fires) sooner than photoelectric alarms. The Kidde i is an AC-powered, ionization smoke alarm that operates on a volt power source with a nine-volt battery backup. This alarm uses ionization sensing technology, and features a spring-loaded front battery door to allow for easy battery change. The Kidde i is an AC/DC powered, ionization smoke alarm that operates on a V power source with 9V battery backup. This alarm uses ionization sensing technology. Ionization sensing alarms may detect invisible fire particles (associated with flaming fires) sooner that photoelectric alarms.

Page 17 If after reviewing this manual you feel that your smoke alarm is defective in any way, do not tamper with the unit. Return it for servicing to: KIDDE, Corporate Park Dr., Mebane, NC (See Warranty for in-warranty returns). • Smoke alarms must be tested regularly to make sure the battery and the alarm circuits are in good operating condition. • Smoke alarms cannot provide an alarm if smoke does not reach the alarm. Therefore, smoke alarms may not sense fires starting in chimneys, walls, on roofs, on the other side of a closed door or on a different floor. The smoke alarm shall be Kidde Model i or approved equal. alarms are wired to a single, continuous (non-switched) power line, which is not pro It shall be powered by a VAC, 60Hz source along with a 9V battery backup. The unit shall incorporate an ionization sensor with nominal sensitivity of to %/ft.