Inficon ic5 manual

parameter are included in the IC/5 Operator's Manual (IPN ). Electronic Document Distribution This manual is available as a PDF document. The PDF file is named www.doorway.ru and is located on the diskette containing the IC/5 Off-Line Editor software. To view the PDF version of this manual, you must have the appropriate Adobe®. Internet Explorer is not supported by this website. Please try a modern browser, like Chrome, FireFox or Safari. There has been a problem loading the page. Please. Inficon IC5 crystal deposition rate controller. Automatic and manual vacuum control capability. CTI 8 cryopump with compressor but unit does not come with a roughing pump. Sold As Is. System can be sold fully tested with warranty for an additional cost.

8. Wait until the IC5 displays "Soak 2" then set the shutter control to "Closed" and press the "F3" "Manual" soft key on the Inficon IC5. 9. Turn the "Frequency" control knob for both axes fully CW then one turn CCW. Warning! This control is counter intuitive. CW decreases the frequency while CCW increases. Inficon IC5 crystal deposition rate controller. Automatic and manual vacuum control capability. CTI 8 cryopump with compressor but unit does not come with a roughing pump. Sold As Is. System can be sold fully tested with warranty for an additional cost. 1. Check the life of the Xtal by pressing the F2 key (Sensors) from the main screen of the Inficon IC5 controller. The value in the "Xtal Actual" column needs to be greater than If it is less than then replace the Xtal. 2. Press the F6 key to return to the Main Menu on the IC5. 3.

Inficon IC5 crystal deposition rate controller. Automatic and manual vacuum control capability. CTI 8 cryopump with compressor but unit does not come with a roughing pump. Internet Explorer is not supported by this website. Please try a modern browser, like Chrome, FireFox or Safari. There has been a problem loading the page. Please. 1. Ensure the Inficon IC5 Deposition Controller is in the “Ready” state. If it is not then press the “Reset” soft key on the front panel. 2. Press the “F6” “Program” soft key. 3. Press the “F2” “Process Directory” soft key. Never Edit “F1” “Material Directory”. 4.