Hayward control panel manual

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 2 Introduction The Hayward Pro Logic is a multifunction pool controller used to fully manage your pool/spa sys-tem. The Pro Logic can control pumps, valves, lighting, heaters, and chlorination. Although the Pro Logic is easy to use, it is important to completely read through this operating manual before. Control box shows LCD display but no LED’s are illuminated. If this is a new install or the circuit board was recently replaced, verify that the board is set up to receive the correct voltage. Jumpers on terminal TB1 are configured for VAC (factory default), but there is VAC applied to control box. VAC VAC Step 4A. Manual. Aspects of the Pro Logic that pertain to system setup are not covered in this manual. Automation The PL-PS-4 (-8, ) can control up to 4 (8, 16) high voltage (/V) pieces of equipment, up to 4 (8 for the PS) automatic valve actuators, and 2 conventional heaters plus a solar heater. Both manual and automaticAuthor: flennox.

FLOW CONTROL. View All Products. HCP ® Series. learn more. GO BACK. MANUALS HOW TO GUIDES Manuals Parts Diagrams. POOL MAINTENANCE Pool Maintenance How a Pool Works Opening Your Pool Closing Your Pool Weekly Maintenance. BUILDING A POOL Hayward Pool Products View FAQs. Contact Hayward Support. HAYWARD LED's/LCD display Control box shows LCD display but no LED's are illuminated. Jumpers on terminal TBI are configured for VAC (factory default), but there is VAC applied to control box. Page DIGITAL CONTROL - All controls of Hayward Universal H-series gas pool heater are digital. They are designed for user's convenience and for easy controlling of the device. Hayward W3HFDN consists of LED digital control panel that provides digital temperature readout, diagnostics and electronic 'lock-out' of temperature set-point.

valve actuators, and a conventional and solar heater. Both manual and automatic (programmed) operation are available. All of the control functions are programmed at the unit’s display/keypad. Although the ECOMMAND 4 has no built-in chlorinator feature, it can control an external Goldline Aqua Rite or Hayward Swimpure chlorinator. 26 Water Air. if the control is set for the wrong Turbo Cell type. The LCD display will read ‘HI’. Verify salt level is ppm and check with independent test to ensure accuracy. If salt level is above the range, partially drain pool and/or spa and refill with fresh water to achieve a salt level of ppm, refer to page 10, Step 2A. The Hayward Pro Logic is a multifunction pool controller used to fully manage your pool/spa system. The Pro Logic can control pumps, valves, lighting, heaters, and chlorination. Although the Pro Logic is easy to use, it is important to completely read through this operating manual before attempting to operate the control.